Here is a quick and dirty rundown of my process.
Film: I have used several different kinds of 16mm film but mostly I use a color intermediate film Eastman 7243 that was not intended to be shot in a camera but used to make duplicates of negatives. This film I rate at asa 12 or asa 6 depending on the situation. This film allows me to use a relatively open aperture on my camera and shoot in bright sunlight. It is low contrast and has a very fine grain. But the real reason I use it … It is really cheap.
Camera: My current go to a Bolex H16 reflex camera. It is reliable and easy to use. The reflex aspect is very nice, I like having my subject in focus. I also use the Filmo 70a for fun or in situations where I don’t want to risk damaging the Bolex.
Camera Settings: I almost never use a light meter. I use the sunny 16 rule and adjust to my situation. Let see – it is sunny and the film is 6 Asa and my shutter speed is twice the reciprocal of my frame rate, so 1/48th of a second – hmmm 6 – 12 – 24 – 48 so I should open up 3 or 4 stops from f/16. It is a lot quicker if I just call it the sunny f/5.6 rule. Of course if I can’t open up enough I can always slow the frame rate down and get an extra stop or two. Anyway this works and once you get used to it, it is pretty quick.
Processing: Again, I am cheap and I like to do stuff myself, so I process everything myself. I don’t like complicated either so I do a very simple hand processing method using the least equipment and chemicals possible. I process in a hand made dark tank. It is a simple affair that is easy and cheap to build. The film is spooled off the daylight reel in a dark room and bunched up and stuffed into the dark tank. Then the film gets a quick wash in a warm borax solution for a couple of minutes, then a rinse in water, a 5 minutes develop in dektol, then a rinse, then a 5 minute soak in fixer and then a final rinse. Let the film hang dry for an hour or two and it’s time for spooling and digitizing.
Digitizing: I fought with this step for quite a while. At first I bought an old B&H projector and just projected the reel and shot the result with whatever camera I had laying a round. But I was unhappy with the results. You can never get the shutter of the camera and projector to line up and the rate was always off, a bad flicker is the result. I tried several methods before I settled on my current setup. I took another old 16mm projector and retrofitted it with a stepper motor drive and a microswitch on shutter. So I can control move the film slowly and precisely through the projector. I also changed the light source to a LED bulb with a diffuser. I use a Canon G5 camera that is aimed back into the lens to individually capture each frame as a high resolution image. It take a couple of hours for the rig to run through and capture a single 100′ of film but I like the results much better. Digitizing one 100′ reel leaves me with about 4000 – 1.5mb images that crop down to a 1600×1200 image so I can do a 1080p movie without losing quality.
Editing: I take the images and drop them into Avidemux for initial processing. This program allows me to crop, rotate, invert the negative and color correct all in one pass. The output can be any number of formats including uncompressed avi’s to highly compress mpeg4’s. I take these files and load them into Sony Vegas pro for the final editing to a youtube or dvd type output.
Here is a quick example of what the files look like before and after processing.
16mm Adventures 